ramips: add support for Wavlink WL-WN578A2

This commit adds support for the Wavlink WL-WN578A2 dual-band wall-plug
wireless router. This device is also sold under the name SilverCrest
SWV 733 A2.

Device Specifications:

- CPU: MediaTek MT7628AN (580MHz)
- Flash: 8MB
- RAM: 64MB
- Bootloader: U-Boot
- Ethernet: 2x 10/100 Mbps
- 2.4 GHz: 802.11b/g/n SoC
- 5 GHz: 802.11a/n/ac MT7610E
- Antennas: internal
- 4 green LEDs: WPS/Power, LAN, WAN, wifi-low, wifi-med, wifi-high
- Buttons: Reset, WPS
- Sliding mode switch: AP, repeater, client
- Small sliding power switch

Flashing instructions:

U-Boot launches TFTP client if WPS button is pressed during power-on.
Configure as follows:

- Server IP: 192.168.10.100
- Filename (rename sysupgrade file to this): firmware.bin

Flashing should not take more than a minute, device will reboot
automatically.

Signed-off-by: Thomas Aldrian <dev.aldrian@gmail.com>

target/linux/ramips/mt76x8/base-files/etc/board.d/01_leds

@@ -129,7 +129,8 @@ wavlink,wl-wn575a3)
 	ucidef_set_led_rssi "wifi-med" "wifi-med" "green:wifi-med" "wlan1" "50" "84"
 	ucidef_set_led_rssi "wifi-high" "wifi-high" "green:wifi-high" "wlan1" "85" "100"
 	;;
-wavlink,wl-wn577a2)
+wavlink,wl-wn577a2|\
+wavlink,wl-wn578a2)
 	ucidef_set_led_switch "lan" "lan" "green:lan" "switch0" "0x8"
 	ucidef_set_led_switch "wan" "wan" "green:wan" "switch0" "0x10"
 	;;

target/linux/ramips/mt76x8/base-files/etc/board.d/02_network

@@ -46,7 +46,8 @@ ramips_setup_interfaces()
 		;;
 	buffalo,wcr-1166ds|\
 	elecom,wrc-1167fs|\
-	wavlink,wl-wn577a2)
+	wavlink,wl-wn577a2|\
+	wavlink,wl-wn578a2)
 		ucidef_add_switch "switch0" \
 			"3:lan" "4:wan" "6@eth0"
 		;;
@@ -168,7 +169,8 @@ ramips_setup_macs()
 		;;
 	cudy,wr1000|\
 	hilink,hlk-7688a|\
-	wavlink,wl-wn577a2)
+	wavlink,wl-wn577a2|\
+	wavlink,wl-wn578a2)
 		wan_mac=$(mtd_get_mac_binary factory 0x2e)
 		label_mac=$(mtd_get_mac_binary factory 0x4)
 		;;