lantiq: xway: rename nas0/ptm0 to dsl0

This change makes it possible to configure the wan/dsl ppp interface
settings independantly from the used TC-Layer (ATM/PTM).

By using dsl0 as interface name as for the xrx200 we can get rid of a
few conditionals which were introduced because of the different default
TC-Layer in xway and xrx200.

Signed-off-by: Mathias Kresin <dev@kresin.me>

target/linux/lantiq/base-files/etc/board.d/01_leds

@@ -20,15 +20,12 @@ led_usb2="$(lantiq_get_dt_led usb2)"
 
 led_dsl="$(lantiq_get_dt_led dsl)"
 [ -n "$led_dsl" ] && {
-	interface="nas0"
-	lantiq_is_vdsl_system && interface="dsl0"
-
 	led_internet="$(lantiq_get_dt_led internet)"
 	if [ -n "$led_internet" ]; then
 		ucidef_set_led_default "dsl" "dsl" "$led_dsl" "0"
 		ucidef_set_led_netdev "internet" "internet" "$led_internet" "pppoe-wan"
 	else
-		ucidef_set_led_netdev "dsl" "dsl" "$led_dsl" "$interface"
+		ucidef_set_led_netdev "dsl" "dsl" "$led_dsl" "dsl0"
 	fi
 }
 

target/linux/lantiq/base-files/etc/board.d/02_network

@@ -18,7 +18,7 @@ encaps="llc"
 payload="bridged"
 lan_mac=""
 wan_mac=""
-interface_wan=""
+interface_wan="dsl0"
 
 board=$(board_name)
 
@@ -230,10 +230,8 @@ ls /lib/modules/$(uname -r)/ltq_atm* 1> /dev/null 2>&1 && \
 	ucidef_add_atm_bridge "$vpi" "$vci" "$encaps" "$payload"
 
 if lantiq_is_vdsl_system; then
-	interface_wan="dsl0"
 	ucidef_add_vdsl_modem "$annex" "$tone" "$xfer_mode"
 else
-	interface_wan="nas0"
 	ucidef_add_adsl_modem "$annex" "/lib/firmware/adsl.bin"
 fi
 

target/linux/lantiq/base-files/etc/uci-defaults/02_migrate_xdsl_iface

@@ -40,8 +40,6 @@ migrate_led_xdsl_ifname()
 	rename_xdsl_ifname system "$1" dev
 }
 
-lantiq_is_vdsl_system || exit 0
-
 config_load network
 config_foreach migrate_network_xdsl_ifname